WEEE Report
Report No.: A2180169984101003 Page 4 of 19
5. Appearance of the Product
6. Disassembly Assessment
6.1 Disassembly Procedure
The product is disassembled into different parts and grouped by the type of material sharing common characteristic( such as plastic,
metal, glass) based on the treatment requirements as set out in the WEEE Directive, followed by the current state of the art of recycling
and recovery technology. In addition, the recycling is subject to the economic feasibility, disassembly tools, only bigger parts that can be
easily separated are included in the recycling and reuse calculation. Other parts, respectively materials that cannot be separated by e.g.
standard tools are classified as either unspecified materials or distributed to the relative waste fraction is expected with recovery rate.