To Next Page

To Previous Page

EL-MF877-00 Page 3

Template Revision B

Figure 2 Rear of HP 7502

1. Unscrew the screws on mounting angle 2, and then remove mounting angle 2;

2. Unscrew the screws on cabling rack 3, and then remove cabling rack 3 from mounting angle 2;

3. Unscrew the screws on front panel 4, and then remove front panel 4;

4. Unscrew the screws on front panel 5, and then remove front panel 5;

5. Unscrew the screws on blank panel 6, and then remove blank panel 6;

6. Unscrew the screws on power supply module 7, and then remove power supply module 7;

7. Unscrew the screws on blank panel 8, and then remove blank panel 8;

8. Unscrew the screws on blank panel 9, and then remove blank panel 9;

9. Unscrew the screws on fan module 10, and then remove fan module 10;

10. Remove film 11;

11. Unscrew the screws on rear cover plate 11, and then remove rear cover plate 11;

12. Unscrew the screws on protection cover 12, and then remove protection cover 12;

13. Unscrew the screws on protection box 13, and then remove protection box 13;

14. Unscrew the screws on rear cover plate 14, and then remove rear cover plate 14;

15. Unscrew the screws on PCB 15, and then remove PCB 15;

16. Remove all of the labels;

17. Remove all of shielding fingers.

3.1.2 Guidance of treatments to module 4:

Figure 3 Treatments to module 4

1. Unscrew the screws on PCB 4-2, and then remove PCB 4-2;

2. Remove shielding finger 4-3 from front panel 4-1;

3. Remove conductive foam 4-4 from front panel 4-1;

Questions and Answers:

Need help?

Do you have a question about the HP 7502 and is the answer not in the manual?

HP 7502 Specifications

General