Part Number A1658–90661
Edition E0895
Printed in U.S.A.
Front View
LED
NOTICE: The first three jumpers
(1, 2, and 3) are the
SCSI ID jumpers. The
only other jumper that
should be
in place
is 7
.
These are the only
jumpers that should be
installed.
J3
1 2 3 4 5 8 9 106 7
SCSI
ID
First
Drive
Second
Drive
6
5
4
3
2
1
0
Quantum Disk Drive Jumpers
Installing Your Disk Drive
(Single–Ended SCSI)
Refer to your workstation owner’s guide or your disk drive installation
guide for detailed information about installing your disk drive. During
the installation procedure, you may have to change the SCSI ID of your
disk drive. Refer to the appropriate illustration to set the SCSI ID jump-
ers to the desired SCSI ID.
NOTICE: We recommend that you use SCSI ID 6
for your workstation’s first hard disk
drive, and SCSI ID 5 for the second hard
disk drive.
To Next Page
Need help?
General