[srcport <
1-34000 >]
Source port.
[ip-option]
Specify an IP option, such as loose or strict source routing, or an include-timestamp
option:[include-timestamp]: Adds the timestamp option to the IP header. The
timestamp displays the amount of travel time to and from a host.Default:
9[include-timestamp-and-address]: Records the intermediate router's
timestamp and IP address.Default: 4[loose-source-route <IP-addr>] :
Prompts for the IP address of each source IP on the path.It allows you to specify the
IP addresses that you want the ping packet to go through; the packet may go through
other IP addresses as well.[record-route <1-9>] : Displays the IP addresses of
the interfaces that the ping packet goes through on its way to the destination and on
the way back.When specified without loose or strict recording, the source route is not
recorded. The source route is automatically recorded when loose or strict source
routing is enabled.Default: 9[strict-source-route <IP-addr>] : Restricts the
ping packet to only those IP addresses that have been specified and no other
addresses.[timeout <1-120>]: For the current instance of traceroute,
changes the timeout period the switch waits for each probe of a hop in the route.For
any instance of traceroute, if you want a timeout value other than the default, you
must specify that value.(Default: 5 seconds)
NOTE: For information about traceroute6, see the IPv6 configuration guide for your switch.
Halting an ongoing traceroute search
Press the [Ctrl] [C] keys.
A low maxttl causes traceroute to halt before reaching the destination address
Executing traceroute with its default values for a destination IP address that is four hops away produces a
result similar to this:
Figure 91: A completed traceroute enquiry
532 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
To Next Page
Loading...
Need help?
General