Validation Error/Warning/Prompt
Configure UDP Jitter/VoIP IPSLA Initiator
session with a source IP same as tunnel overlay
VLAN
Cannot enable IP SLA: The source VLAN cannot be a tunnel
overlay VLAN.
Configure UDP Jitter/VoIP IPSLA Initiator
session with a source IP same as a service
tunnel endpoint.
Cannot enable IP SLA: The source VLAN cannot be a service
tunnel endpoint.
Event log messages
Cause
Event Message
User adds IP SLA endpoint configuration. I 10/28/15 02:47:12 05020 ipsla: The IP SLA 1 of
SLA Type: UDP-Echo, Source IPv4 Address:
10.0.0.1, Destination IPv4 Address: 10.0.0.5,
Destination Port: 54563 added.
User removes the endpoint configuration. I 10/28/15 02:47:12 05021 ipsla: The IP SLA 1 of
SLA Type: UDP-Echo, Source IPv4 Address:
10.0.0.1, Destination IPv4 Address: 10.0.0.5,
Destination Port: 54563 removed.
When the SLA state changes (can be either system
initiated or done by the user)
I 10/28/15 01:42:22 05027 ipsla: IP SLA 1 state
changed to Expired.I 10/28/15 01:42:22 05021 ipsla:
IP SLA 1 state changed to Enabled.I 10/28/15
01:42:22 05021 ipsla: IP SLA 1 state changed to
Scheduled.I 10/28/15 01:42:22 05021 ipsla: IP SLA
1 state changed to Admin-disabled.
User configures a responder I 10/28/15 01:42:22 05025 ipsla: IP SLA responder
configured for SLA Type: TCP-Connect, Listen
Address: 10.0.0.7, Listen Port: 38425
User removes a responder I 10/28/15 01:42:22 05026 ipsla: IP SLA responder
removed for SLA Type: TCP-Connect, Listen
Address: 10.0.0.7, Listen Port: 38425
SLA test results cross configured threshold I 10/28/15 01:42:22 05022 ipsla: IP SLA 1, threshold
is crossed. Monitored Param: RTT, Threshold Type:
immediate, Upper threshold: 500, Lower threshold:
100, Action Type: Trap and Log. Actual Threshold:
600
User adds DNS IP-SLA configuration I 08/09/16 02:47:12 05029 ipsla: The IP SLA 1 of
SLA Type: DNS, Name server IPv4 Address:
10.0.0.1, Target Hostname: a.hpe.com added
Table Continued
Chapter 17 IP Service Level Agreement 603
To Next Page
Loading...
Need help?
General