Syntax
oobm enable oobm disable
Enables or disables networked OOBM on the switch.
OOBM is not compatible with either a management VLAN or stacking. If you attempt to enable OOBM when a
management VLAN is enabled or when stacking is enabled, the command will be rejected and you will receive an
error message.
If an OOBM IP address exists and you disable OOBM, the OOBM IP address configuration is maintained. If you
enable OOBM and there is a pre-existing OOBM IP address, it will be reinstated.
Network OOBM is enabled by default.
Examples
Switch (oobm)# enable
Switch (oobm)# disable
switch(config)# oobm enable
switch(config)# oobm disable
Enabling and disabling the OOBM port
The OOBM interface command enables or disables the OOBM interface (that is, the OOBM port, as opposed
to the OOBM function.)
From the OOBM context:
Syntax
interface [enable | disable]
From the general configuration context:
Syntax
oobm interface [enable | disable]
Enables or disables the networked OOBM interface (port.)
Examples
Switch (oobm)# interface enable
switch(config)# oobm interface disable
Setting the OOBM port speed
The OOBM port operates at 10 Mbps or 100 Mbps, half or full duplex. These can be set explicitly or they can be
automatically negotiated using the auto setting.
From the OOBM context:
Syntax
interface speed-duplex [10-half | 10-full | 100-half | 100-full | auto]
From the general configuration context:
Chapter 22 Network Out-of-Band Management (OOBM) 735
To Next Page
Loading...
Need help?
General