List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Size (if
applicable)
Description #1 SCREW DRIVER(PHILLIPS HEAD)
Description #2 SCREW DRIVER(PHILLIPS HEAD)
Description #3 SCREW DRIVER(PHILLIPS HEAD)
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1. Remove Stand Base From Display Head
2. Remove Rear Cover From Display Head
3. Remove speaker From Display Head
4. Remove Hinge From Main bracket
5. Remove down bracket From Main bracket
6. Remove main bracket from Panel
7. Remove Bezel from panel
8. Disassemble Bezel ASSY
9. Disassemble Rear Cover ASSY
10. Take Screw(*2) Off From Chassis Cover
11. Take Screw(x12) Off From P.C.B
12. Remove Gasket From Chassis Cover
13. Remove Gasket From left and right Brakcet
14. LCD PANEL EXPLODE
15. Hinge and Base
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items
contained in the product that require selective treatment (with descriptions and arrows identifying locations).
EL-MF877-00 Page 2
Template Revision A
To Next Page
Loading...
Need help?
General
