HP ProDisplay P221 User Manual

© Copyright 2012, 2013 Hewlett-Packard Development Company, L.P.
ENERGY STAR® is a US registered mark of the United States Environmental Protection Agency.
1
The HP Quick Release has been designed to support a maximum of up to 24 lbs (10.9 kg) for all devices mounted. Because mounting
surfaces vary widely and the final mounting method and configuration may vary, mounting fasteners are not supplied (other than the
VESA-compliant screws). HP recommends that you consult with a qualified engineering, architectural or construction professional to
determine the appropriate type and quantity of mounting fasteners required for your application and to ensure that your mounting
solution is properly installed to support applied loads.
2
Service levels and response times for HP Care Pack Services may vary depending on your geographic location. Service starts from
date of hardware purchase. Restrictions and limitations apply. HP Care Pack Services extend service contracts beyond the standard
warranties. To choose the right level of service for your HP product, use the HP Care Pack Services Lookup Tool at
www.hp.com/go/lookuptool . Additional HP Care Pack Services information by product is available at www.hp.com/hps/carepack .
3
EPEAT® Gold where HP registers commercial display products. See www.epeat.net for registration status in your country.
4
Arsenic and its compounds were not detected using US EPA Test Methods 3052 & 3052/6010b by ICP or ICP-AES.
5
External power supplies, power cords, cables and peripherals are not Low Halogen. Service parts obtained after purchase may not be
Low Halogen.
All specifications represent the typical specifications provided by HP's component manufacturers; actual performance may vary either
higher or lower. The only warranties for HP products and services are set forth in the express warranty statements accompanying such
products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or
editorial errors or omissions contained herein.
QuickSpecs
HP ProDisplay P221 21.5-inch LED Backlit Monitor
Technical Specifications
DA - 14489 Worldwide — Version 6 — July 12, 2013 Page 8

HP ProDisplay P221 Specifications

General

Pixel pitch	0.248 x 0.248 mm
Display diagonal	21.5 \
Viewing angle, vertical	160 °
Contrast ratio (dynamic)	3000000:1
Contrast ratio (typical)	1000:1
Display number of colors	-
Viewing angle, horizontal	170 °
Display brightness (typical)	250 cd/m²
HDCP	Yes
HDMI ports quantity	0
Product color	Black
Country of origin	China
Market positioning	Business
Tilt angle range	-5 - 25 °
Panel mounting interface	100 x 100 mm
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.5 W
Power consumption (typical)	22 W
Sustainability certificates	ENERGY STAR

Weight and Dimensions

Depth (with stand)	160 mm
Height (with stand)	379 mm
Depth (without stand)	47.5 mm
Width (without stand)	518 mm
Height (without stand)	315.2 mm
Weight (without stand)	4000 g