To Next Page

DVD-ROM and DVD-RW Drive

Option

Installation Instructions

for HP ProLiant DL360 G6 Servers

Overview

This document provides instructions for installing a SATA DVD-ROM or

DVD-RW drive. When you install this drive, the server does not support

the additional hard drive backplane.

Kit contents

• DVD-ROM or DVD-RW drive

• DVD tray

• T-10 screws (3)

• SATA optical drive cable

• This document

Installing the DVD-ROM or

DVD-RW drive

1. Power down the server, and then disconnect all power cords to

remove power from the server.

2. Extend the server from the rack.

3. Remove the access panel.

4. Remove the dual hard drive bezel blank.

5. Install the optical drive in the DVD tray.

6. Secure the drive to the tray using the screw from this kit and the

T-10/T-15 Torx screwdriver provided with the server.

7. Install the DVD tray using the screws from this kit and the

T-10/T-15 Torx screwdriver provided with the server.

8. Remove the BBWC battery, if installed.

The information contained herein is subject to change without notice. The only

warranties for

HP products and services are set forth in the express warranty

statements accompanying such products and services. Nothing herein should

be construed as constituting an additional warranty. HP shall not be liable for

technical or editorial errors or omissions contained herein. Bluetooth is a

trademark owned by its proprietor and used by Hewlett-Packard Company

under license.

Part Number: 517695-002

March 2012

Edition: 2

HP ProLiant DL360p Installation Instructions

Other manuals for HP ProLiant DL360p