NOTE:
The DON’T ERASE logical disk supports the Quick Restore process
only and does not host the secondary operating system. If you need to
perform a quick restore of your server, see the Quick Restore Instructions
insidetheQuickRestoreDVD.Besuretobackupyouruserdata,and
then use the Quick Restore DVD to restore the server to the factory
default state
On the ML110 G1 and DL100, when the primary OS has a failure such
as system files becoming corrupted, registry corrupted, or the system hangs
during bo ot, the system should be run from the secondary OS. To run
the system from the secondary OS:
1. Power down the unit.
2. Connect a monitor, keyboard, and mouse directly to the rear of the
unit.
3. Power on the unit.
4. During boot up, select to use the secondary partition.
Be sure to back up your user data, and then use the Quick Restore DVD
to restore the server to the factory default state as soon as conveniently
possible.
Storage for 300 series and 500 series ProLiant storage
servers
The 300 series and 500 series ProLiant Storage Servers are preinstalled at
the factory with the operating system only. Additional storage configuration
is needed for the creation of data drives. Depending on the type of storage
server, storage configuration can i nvolve local storage configuration via
the HP Array Configuration U tility, Adaptec Storage Manager, or SAN
management tools.
Physical drive configuration
Each300seriesand500seriesProLiantStorageServercomeswith
two hot-pluggable HDD s for the operating system only. The drives are
HPProLiantStorageServeruserguide
45
To Next Page
Loading...
Need help?
General
