Components, parts and materials containing
refractory ceramic fibers
List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1. Lay the monitor on a flat, soft and clean surface.
2. Pull up the bezel
3. Release the screws to remove rear cover
4. Release the screws to remove cover, key and magnets
5. Disconnect the connector to remove the cable
6. Release the screws to remove main board
7. Remove the mylar
8. Panel
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items
contained in the product that require selective treatment (with descriptions and arrows identifying locations).
To Next Page
Loading...
Need help?
General
