1.
Source
Selects the video input (DisplayPort or DVI-
D)
4.
Power
Turns the monitor on or off
2.
- (Minus)
Reduces the brightness setting
5.
Power LED
Sleep mode - amber; Continuous flashing
blue - non-supported video mode; Three
flashes of blue - upper or lower limit of
brightness control; Four flashes of blue -
DCR is enabled; One flash of blue - DCR is
disabled; Steady blue - full power and
monitor is displaying a supported mode
(LED automatically turns off after 30
seconds)
3.
+ (Plus)
Increases the brightness setting
NOTE:
Pressing the + (Plus) and - (Minus) buttons at the same time enables or disables the Dynamic Contrast Ratio (DCR) function.
When enabling the DCR function, the power LED will flash four times. When disabling the DCR function, the power LED will flash one
time.
Model
VM617A4
QuickSpecs
HP ZR30w 30-inch S-IPS LCD Monitor
Overview
DA - 13635 North America — Version 9 — January 29, 2013
Page 1