Fan Speed: Set low or high speed. During the comfortable mode
("AU") when the room temperature is more than 27 degree, the
wind speed is fixed.
Set the humidity level (up, down): Press the button up to increase
or down to decrease the humidity level. You can set humidity from
90% to 30% in 5% increments. Default mode is the “CO”.
Continuous cycle.
Note: Press UP and DOWN at the same time to convert display of
temperature or humidity, the indicator “℃” being for temperature
and “%” for humidity
Timer: The appliance has 24 hours. Each time you press the
button, it will increase 1 hour. To cancel the timing press the key
again.
Mode: When power on or timing power on, press this button to
choose dry cloth, fan or dehumidification function. The lights will
flash when choose the modes.
Child lock: Press the key for 5 second to turn on that function.
Once child lock turns on, all button operations except child lock
buttons cannot be operated.
Note: After the operation is completed 10S, all lights are all
dimmed.
INSTRUCTIONS FOR USE:
Unroll the cable completely before plugging it in.
Make sure that the water tank is set properly.
Note: If the water tank is full, the water indicator light will be on and
the rest are not displayed.
Plug the appliance to the mains
Connect the appliance to the mains.
Press the on/off button to turn on/off the unit.
The power indicator will light on.
The current humidity will be displayed with the defaults of
continuous mode "CO", and the compressor will then start
immediately for dehumidification
Press this button to turn on/off the unit.
Do not unplug the power cord directly to force the machine stop
working directly.
To Next Page
Loading...
Need help?
General
