Thank you for choosing Mobile Broadband E1550
E1550 ( hereinafter referred to as the E1550).
Note:
This manual briefly describes the appearance, the preparation and the process for
installing/uninstalling.
Getting to Know your E1550
The following figures show the appearance of the E1550. The actual product may differ.
n Micro SD card slot
Holds the Micro SD card.
o USIM/SIM card slot
Holds the USIM/SIM card.
p Lanyard Hole
ap and the E1550 together so that they will not be easily lost. Ties the c
Note:
The lanyard is an optional accessory. If it is not provided in the package, you can buy one
urself.
yo
q USB connector
Connects to the USB interface of the PC.
red to the 3G/3G+ network.
t up.
rom the PC.
2. the Micro SD card into the card slots. Make sure that the
cards are properly inserted.
r Indicator
Indicates the status of the E1550.
z Green, blinking twice every 3s: The E1550 is powered on.
z Green, blinking once every 3s: The E1550 is registered to the 2G network.
z Blue, blinking once every 3s: The E1550 is registe
z Green, always on: The 2G connection is set up.
z Blue, always on: The 3G connection is set up.
z Cyan, always on: The 3G+ connection is se
z Off: The E1550 is removed f
Preparing the E1550
1. Take out of the back cover of the E1550.
Insert the USIM/SIM card and
z y. If the Micro SD card is not provided in the
z
ge the cards as well as the device,
and data stored on the cards may be corrupted.
Note:
Micro SD card is an optional accessor
package, you can buy one yourself.
Do not remove the USIM/SIM card and the Micro SD card when they are being used.
Removing the cards during an operation may dama
To Next Page
Need help?
General
