Step 4 After the management module is started, use the default parameters to log in to the
management module command-line interface (CLI). The default user name is Administrator,
and the default password is Admin@9000.
Step 5 Modify the user name and password as required and record the information.
----End
Follow-up Procedure
After the configuration is complete, remove the jumper cap or other short circuit tools.
5.3.5 Configuring Basic Management Module Data
Configure basic management module data.
Prerequisites
Log in to the management module CLI.
Procedure
Step 1 Configure a management module IP address.
NOTICE
After the IP address is configured, the new IP address takes effect immediately, and you must
use the new IP address to log in again.
On the management module CLI, run one of the following commands to configure basic
management module data.
l Setting an IPv4 address: ipmcset -d ipaddr -v <ipaddr> <mask> [gateway]
l Setting an IPv6 address: ipmcset -d ipaddr6 -v <ipaddr6/prefixlen> [gateway6]
Table 5-6 describes the parameters in the ipaddr and ipaddr6 command.
Table 5-6 Parameter description
Parameter
Description Value
ipaddr Specifies the IPv4 address of
the network port to be
configured.
The value of this parameter is in the
data type of IPv4 and in the format of
xxx.xxx.xxx.xxx.
mask Specifies the subnet mask of
the network port to be
configured.
The value of this parameter is in the
data type of IPv4 and in the format of
xxx.xxx.xxx.xxx.
gateway Specifies the gateway
address of the network port
to be configured.
The value of this parameter is in the
data type of IPv4 and in the format of
xxx.xxx.xxx.xxx.
FusionServer G5500 Server
User Guide
5 Configuring the G5500
Issue 02 (2017-12-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
81
To Next Page
Loading...
Need help?
General
Weight and Dimensions
