English - 51
6. MENU FUNCTIONS
6.5 Installation (3)
From this option in the main menu you access the
driving settings.
• Exit angles (3-1)
to set how far Automower
®
should reverse out of
the charging station before it turns and in what
direction the mower should leave the charging
station.
• Follow loop (3-2)
to guide the mower to easily reach a remote area
of the garden, to make it easier to find the
charging station and to determine at what
distance the mower shall follow the loop.
• Installation shape (3-3)
to tell Automower
®
which type of garden you have.
• Advanced (3-4)
tto check that the loop is intact or exactly where in
the lawn the wire is buried and to adjust the
distance over the boundary wire that Automower
®
shall run.
For examples of Installation settings, see 7. Garden
example - Proposed installation and settings on
page 61.
Exit angles (3-1)
Normally Automower
®
leaves the charging station in
a direction within the exit sector 90°-270°, where 90°
is called the Start angle and 270° is called the End
angle. By setting the start and end angles, you can
set the direction in which Automower
®
is to leave the
charging station.
• Reversing distance (3-1-1)
Specify the number of centimeters you want
Automower
®
to reverse before it turns to drive
out of the charging station.
The default reversing distance is (24"(60 cm)).
• Start angle 1 (3-1-2)
Specify in degrees where you want the
sector/sector 1 to start.
• End angle 1 (3-1-3)
Specify in degrees where you want the
sector/sector 1 to end.
3-
3
Exit angles
Follow loop
Installation shape
Advanced
Commands
Timer
Installation
Settings
3-1
3-1-
Reversing dist.
Start angle 1
End angle 1
Exit angles
Follow loop
Installation shape
Advanced
To Next Page
Loading...
Need help?
General
