Installation of Wheels to Powermax900
Kit: 128316
Page 2 of 3
WARNING
SHOCK HAZARD: Always turn off power and unplug cord from wall before installing wheels on the
power supply. If power unit is directly connected to a line disconnect box, place line disconnect
switch to OFF position. Lock out and tag out switch before proceeding!
1. If the torch is connected to the power supply,
unscrew and remove it.
2. Remove the screws (075467- qty. 18) that
secure the cover to the power supply
chassis.
3. Remove the power supply cover.
4. Carefully tilt the power supply forward on to its
front handle.
5. Align the right chassis stiffener (001555) to the
bottom of the power supply - see Fig. 2 for
outside view. Be certain that the holes in the
chassis stiffener are offset to the far left side
with two holes on the top and four holes on the
bottom.
6. Attach the right chassis stiffener to the power
supply chassis:
• Push 2 of the screws (075472) through the
top 2 holes of the chassis stiffener from the
outside (bottom) of the power supply - see
Fig. 1. Be certain that the screws also go
through the holes of the chassis floor.
• Hand tighten 2 of the kepnuts (075160) to
the screw ends that protrude through the
chassis floor.
Figure 1 Power Supply on Front Handles -
Inside Floor View
Push 075472 screws through
these 2 holes from the outside
(bottom) of the power supply.
Holes to mount
right caster.
Right chassis stiffener 001555
on far side.
To Next Page
Loading...
Need help?
General
