16
US
If OUT OF SCAN RANGE appears on line 1
This indicates that the input signal is not supported by the
monitor’s specifications.
For more information, see “Trouble symptoms and remedies” on
page 17.
Displaying this monitor’s name, serial number,
and date of manufacture
While the monitor is receiving a video signal, press and hold the
button for more than 5 seconds to display this monitor’s
information box.
If the problem persists, call your authorized technical support and
give the following information.
• Model name: IBM P275
• Serial number
• Name and specifications of your computer and graphics board.
2 The selected video input connector and the
frequencies of the current input signal
This message shows the currently selected video input
connector (INPUT 1 or INPUT 2). If the monitor recognizes
the frequencies of the current input signal, the horizontal and
vertical frequencies are also displayed.
3 The remedies
CHANGE SIGNAL TIMING appears on the screen. If you
are replacing an old monitor with this monitor, reconnect the
old monitor. Then adjust the computer’s graphics board so
that the horizontal frequency is between 30 – 130 kHz, and the
vertical frequency is between 48 - 170 Hz.
W
R
G
B
IIONNFORMAT
MON I I I NGS WORKTOR
I 2 :200.0kHz/ 85Hz
RANGE
S GNAL TIIINGM
NPUT
OUT OF SCAN
CHANGE
W
R
G
B
SER NO
:
12-34567
MODEL
:
IBM P275
MANUFACTURED
: 2001-05
INFORMATION
Example
b
To Next Page
Loading...
Need help?
General
