a. Press the fan-cage release latches on the top and bottom of the fan cage
toward the sides of the server. The cage lifts slightly when the release
latches are fully open.
b. Grasp the cage and lift it out of the server.
14. If the tape drive came with screws, secure the drive to the server chassis,
using the supplied screws.
Optical drive
power cable
SATA optical
drive signal cable
USB signal
cable
USB signal
cable connector
Optical drive
power cable
15. Connect one end of the tape drive cable to the USB or SATA connector on the
system board, depending upon the type of tape drive that you are installing;
then, route the cable through the cable holders on the inside of the server and
connect the opposite end of the cable to the back of the tape drive.
Chapter 2. Installing optional devices 59
To Next Page
Loading...
Need help?
General