5 - 4
1
1
2
3
1
1
2
• Operating frq. :156.800 MHz
• Output power : Low
• Connect an RF power meter or a 50 Ω
dummy load to the antenna connector.
• Transmitting
• Operating frq. : 156.800 MHz
• Output power : Hi
• Transmitting
• Output power : Low
• Transmitting
• Output power : Extra-Low
• Transmitting
• Operating frq. : 156.800 MHz
• Output power : Low
• Connect an audio generator to the [MIC]
jack and set as:
1 kHz/25 mV
• Set an FM deviation meter as:
HPF : OFF
LPF : 20 kHz
De-emphasis : OFF
Detector : (P–P)/2
• Transmitting
• Operating frq. : 156.800 MHz
• Set an SSG as:
Frequency : 156.800 MHz
Level : 0.63 µV*
(–111 dBm)
Modulation : 1 kHz
Deviation : ±3.5 kHz
• Receiving
• Receiving
REFERENCE
FREQUENCY
[Fr]
OUTPUT
POWER
[Po H] (Hi)
[Po L] (Low)
[Po ML]
(Extra-Low)
FM
DEVIATION
[dE]
SQUELCH
LEVEL
[nL]
Top
Panel
Top
panel
Top
panel
Top
panel
Loosely couple the frequency
counter to the antenna connec-
tor.
Connect an RF power meter to
the antenna connector.
Connect an FM deviation meter
to the antenna connector
through an attenuator.
Connect an SSG to the antenna
connector and a SINAD meter
with 8 Ω load to the [SP] jack.
156.8000 MHz
5.0 W
0.8 W
0.45 W
±4.3 kHz
More than 12 dB
SINAD
• Push [Z] key to
set squelch level
to “01” at the sub
channel readout.
• Then, push [Y]
key to set squelch
level to “00” at the
sub channel read-
out.
ADJUSTMENT ADJUSTMENT CONDITION
MEASUREMENT
VALUE
UNIT
LOCATION
5-3 ADJUSTMENT MODE ADJUSTMENTS
Select an operation using [16] key, then set specified value using [Y] / [Z] keys on the front panel of IC-M32.
*The output level of the standard signal generator (SSG) is indicated as the SSG’s open circuit.
TX power Hi/Low is selectable on all adjustment items.