25
SCAN OPERATION
6
■ Scan types
Scanning searches for signals automatically and makes it
easier to locate new stations for contact or listening purposes.
There are 5 scan types and 4 resume conditions to suit your
operating needs.
FULL SCAN ((p. 26))
Repeatedly scans all frequen-
cies over the entire band.
Some frequency ranges are
not scanned according to the
frequency coverage of the re-
ceiver’s version.
10
kHz
3299.9999
MHz
Scan
Jump
ALL/SELECTED BANK
SCAN ((p. 26))
Repeatedly scans all bank
channels or selected bank
channels. The skip scan is
also available.
SKIP
SKIP
A99
A03
A00 A01 A02
A04
A98
A05
PROGRAMMED SCAN
((p. 26))
Repeatedly scans between
two user-programmed fre-
quencies. Used for checking
for frequencies within a speci-
fied range such as repeater
output frequencies, etc.
Band
edge
xxA xxB
Band
edge
Scan edges
Scan
Jump
MEMORY (SKIP) SCAN
((p. 26))
Repeatedly scans memory
channels except those set as
skip channel. Skip channels
can be turned ON and OFF
by pushing and holding
[MR•SKIP] in memory mode.
SKIP
SKIP
M 0
M 4
M 1 M 2 M 3
M 5
M 199
M 6
FREQUENCY/MEMORY
SKIP FUNCTION ((p. 28))
Skips unwanted frequencies
or channels that inconve-
niently stop scanning. This
function can be turned ON
and OFF by pushing and
holding [MR•SKIP] in memory
mode.
Band
edge
Band
edge
Scan
SKIP SKIP
Jump
To Next Page
Loading...
Need help?
General
