Icom IC-V85 Step-by-Step Programming Guide
Also applies to IC-V80
Noji Ratzlaff
Set the radio to communicate with a repeater at 146.780- MHz, 100.0 Hz
0. Turn on the radio and make sure it’s unlocked
1. CLR (VFO mode)
2. Set the frequency
1 - 4 - 6 - 7 - 8 - 0
3. If the – sign appears at the top, skip to step 6
4. Set the repeater offset
FUNC - 8 - (± 0.60) - CLR
5. Set the repeater shift direction
FUNC - 4 (–)
6. Set the transmit tone frequency
FUNC - 8 (rt) - rotate volume (100.0) - CLR
FUNC - 1 (*)
7. Set the transmit power level
FUNC - 9 (H) - CLR
Your radio is now set to transmit as specified
Store and name the current repeater and tone settings in a memory channel
0. Follow the procedure above to set your radio
for the frequency of your choice
1. Store the frequency in channel 37
FUNC - MR - (37) - FUNC - MR (hold)
The frequency is now stored in radio memory
2. MR (channel mode)
3. Set NAME mode
FUNC - 8
(If this doesn’t put you in name edit mode,
turn off the radio, then and and PWR
simultaneously, then select dSP.Nm)
4. Rotate the knob and then to edit the name,
then CLR
The stored memory channel now has a name
Recall a stored memory setting
0. Turn on the radio and make sure it’s unlocked
1. MR (channel mode)
2. Select the two-digit channel number
3 - 7
The stored channel is now ready for use
To Next Page
Need help?
General
