Icom IC-W2A Instruction Manual

ms |
Before operation
Some keys on the front panel have 3 or 4 different functions.
The function depends on the following procedures:
Activated for frequency setting after
(1~0) pushing [#@ ENT].
Functions written : : ;
Activated by simply pushing the key.
Functions written | Activated by pushing the key while push-
in blue ing [F] on the side panel.
Digits and letters | Activated for DTMF transmission while
(1~0 and A~D) | [PTT] is being pushed.
[EXAMPLE]:
Push this key:
Switches VFO and Push this key
MEMORY mode. while pushing [F]:
/ Writes the displayed
Push this key after = data into a memory
pushing [(@ ENT): 1 channel.
Inputs ‘'1"' for
frequency entry.
[@ V/M] and [@) MW] are used here as examples.
BASIC OPERATION
& Charge the battery pack
The supplied battery pack may require a full charge prior to
operation.
Turn the transceiver power OFF and then connect the sup-
plied wall charger as described in the diagram below.
* The CPU back-up battery will also be fully charged.
* See p. 12 or p. 14 for details on safety and use of a desktop charg-
er or battery case.
Charging time 15 hrs. (approx.)
CAUTION:
DO NOT forget to attach the jack cap
after battery charging is finished. The jack cap prevents
bad contact caused by dust.

Icom IC-W2A Specifications

General

Brand	Icom
Model	IC-W2A
Category	Transceiver
Language	English