Page 5
WARNING
Arc Flash and Shock Hazard, Proper PPE Required. Follow all safety procedures, wear proper PPE
in accordance to NFPA 70E and follow the guidelines below and the instructions in this manual
when operating the meter. Failure to comply can result in serious injury or death.
• Arc Flash and Shock Hazard, Proper PPE Required. Follow all safety procedures, wear proper
PPE in accordance to NFPA 70E and follow the guidelines below and the instructions in this
manual when operating the meter. Failure to comply can result in serious injury or death.
• Have the Tracer serviced only by qualified service personnel.
• Do not use the Tracer around explosive gas, dust, or vapor, or during electrical storms, or in
wet environments.
• Do not apply more than the rated voltage, as marked on the Transmitter, between the terminals
or dbetween any terminal and earth ground.
• To avoid false readings that can lead to electrical shock and injury, replace the batteries as
soon as the low battery indicator ( ) appears.
• Remove the test leads from the circuit prior to removing the battery door.
• Voltages exceeding 30VAC RMS or 60VDC pose a shock hazard so use caution.
• Always ensure that test leads are secured so that they cannot be accidentally snagged or
tripped over.
• Do not work alone so that assistance can be rendered in an emergency. Use extreme caution
when working around bare conductors or bus bars. Contact with the conductor could result in
electric shock.
• Adhere to local and national safety codes. Individual protective equipment must be used to
prevent shock and arc blast injury where hazardous live conductor are exposed.
• Never operate the Tracer with the back cover removed or the case open.
• Cancer and Reproductive Harm - www.P65Warnings.ca.gov
CAUTION
Tracer damage, equipment under test damage or data loss can occur if the following guidelines
are not adhered to.
• Use the proper terminals, function, and range for the tracing/measurement application.
• Clean the case and accessories with a damp cloth and mild detergents only. Do not use
abrasives or solvents. Make sure the tracer is completely dry before use.
CAUTION:
The TR-946 transmitter is rated for 0 to 480 Volts AC 50 or 60 Hz or DC. The TR-948 transmitter
is rated for 0 to 600 Volts AC 50 or 60 Hz or DC. It is not compatible with non-sinusoidal or
distorted waveforms as are found at the output of variable drives, dimmer switches or in the
presence of harmonically distorted waveforms. Connecting to these sources will damage the
transmitter. Shipboard inverters can also cause damage to the transmitter.
To Next Page
Need help?
General
