C42 SERIES Pilot Operating Handbook
POH Issue 4 Rev. 5 Page 65 of 91
Please be advised that towing glider planes or banner is subject to
authorization of local authorities and is independent on the airplanes
capabilities.
II. Banner tow
1. Equipment in the towing aircraft
In order to perform a banner tow, the aircraft must be equipped with the
same equipment as described above for towing gliders.
The following propellers are approved for banner towing when the aircraft
is equipped.
with a ROTAX 912 UL (80 PS):
1. Warp Drive, 3 bladed, 68"
2. Neuform CR3-75, 3 bladed, ground adjustable propeller
3. Kiev Prop BB 263/1700, 3 bladed, ground adjustable propeller
with a ROTAX 912 S/ULS (100 PS):
1. Warp Drive 3-blade
2. Neuform 3-blade CR3-V-R2H variable pitch propeller
3. Neuform 3-blade CR3-75
4. Kiev Prop BB 283/1800 3-blade
Banners may only be picked up and towed according to approved
procedures and by aircraft with the appropriate equipment.
Banners must be made of water-resistant material.
Only banners may be used which correspond to the products
requirements defined by the organisations DAeC and DULV.
To Next Page
Loading...
Need help?
General
