ENGLISH 14
Problem Possible causes: Solutions:
The front edge of the
appliance that the door
gaskets seal against is hot.
This is not a defect. It
prevents condensation
from forming.
No solution is necessary.
One or more green
symbols are ashing
continuously and it is not
possible to change the
temperature set.
Malfunction alarm.
The alarm indicates a fault
in a technical component.
Contact Technical Assistance
Service.
The temperature of the
refrigerator compartment
is too cold.
• The set temperature is
too cold.
• A large amount of fresh
food may have been
placed in the freezer
compartment.
• Try to set a less cold
temperature.
• If fresh food has been placed
in the freezer compartment,
wait until it has fully frozen.
• Turn off the fan (if present)
following the procedure
described in the paragraph
“FAN”.
Note:
it is normal for the refrigeration system to produce some noises, such as gurgling and hissing.
What to do if...
Before contacting the After-Sales Service:
Restart the appliance to see if the fault
has been remedied. If it persists, switch
the appliance off again and repeat the
operation after an hour.
If your appliance still does not work
properly after carrying out the checks listed
in the troubleshooting guide and switching
the appliance on again, contact the After-
sales Service, clearly explaining the problem
and specifying:
• the nature of the problem
• the model
• the type and serial number of the
appliance (given on the rating plate)
• the Service number (the number after the
word SERVICE on the rating plate inside
the appliance).
To Next Page
Loading...
Need help?
General
