The higher the content of these minerals, the
harder your water is. Water hardness is
measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water in
your area. It is important to set the right
level of the water softener to assure good
washing results.
Water hardness
German degrees
(°dH)
French degrees
(°fH)
mmol/l Clarke de-
grees
Water softener level
47 - 50 84 - 90 8.4 - 9.0 58 - 63 10
43 - 46 76 - 83 7.6 - 8.3 53 - 57 9
37 - 42 65 - 75 6.5 - 7.5 46 - 52 8
29 - 36 51 - 64 5.1 - 6.4 36 - 45 7
23 - 28 40 - 50 4.0 - 5.0 28 - 35 6
19 - 22 33 - 39 3.3 - 3.9 23 - 27
5
1)
15 - 18 26 - 32 2.6 - 3.2 18 - 22 4
11 - 14 19 - 25 1.9 - 2.5 13 - 17 3
4 - 10 7 - 18 0.7 - 1.8 5 - 12 2
<4 <7 <0.7 < 5
1
2)
1)
Factory setting.
2)
Do not use salt at this level.
How to set the water softener level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
simultaneously and until
the indicators
, and start
to flash and the display is blank.
2. Press
• The indicators and go
off.
• The indicator continues to flash
• The display shows the current setting:
e.g. = level 5.
3. Press repeatedly to change the
setting. Each time you press the level
number increases. After level 10 you will
start again from level by 1
4. Press the on/off button to confirm the
setting.
Use of rinse aid and multi-tablets together
When you activate the option Multitab, the
rinse aid dispenser no longer releases rinse
aid. However if you are using multi-tablets
and the drying results are not satisfactory,
we suggest to use multi-tablets and rinse
aid together. In this case you have to
activate the rinse aid dispenser.
ENGLISH 11
To Next Page
Loading...
Need help?
General
