IKEA FRYSA User Manual

Problem Possible cause Solution
Water flows on the floor. The melting water outlet is
not connected to the evap-
orative tray above the
compressor.
Attach the melting water outlet
to the evaporative tray.
Temperature cannot be set. The FastFreezing function
is switched on.
Switch off FastFreezing func-
tion manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FastFreezing function".
DEMO appears on the dis-
play.
The appliance is in demon-
stration mode.
Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and dis-
play shuts off for a short time.
The temperature in the ap-
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera-
ture.
The temperature in the ap-
pliance is too low/too high.
The food products temper-
ature is too high.
Let the food products temper-
ature decrease to room tem-
perature before storage.
The temperature in the ap-
pliance is too low/too high.
The door has been
opened too often.
Open the door only if necessa-
ry.
The temperature in the ap-
pliance is too low/too high.
The FastFreezing function
is switched on.
Refer to "FastFreezing func-
tion".
The temperature in the ap-
pliance is too low/too high.
There is no cold air circula-
tion in the appliance.
Make sure that there is cold
air circulation in the appliance.
Door does not open easily. You attempted to re-open
the door immediately after
closing.
Wait a few seconds between
closing and re-opening of the
door.
If your appliance is still not
working properly after making
the above checks, contact the
Authorised Service Centre. You
can find the list at the end of this
manual.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
ENGLISH 16

IKEA FRYSA Specifications

General

Brand	IKEA
Model	FRYSA
Category	Refrigerator
Language	English