EasyManuals Logo
Home>IKEA>Dishwasher>LAGAN

IKEA LAGAN Use & Care Guide

IKEA LAGAN
25 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
14
EN
WATER SUPPLY CONNECTION
Figure 1
Brass
Compression
Nut
Water Valve
Bracket
Valve Inlet
Water Valve
Copper water line from
household water supply
(Include enough tubing in loop to allow
moving refrigerator out for cleaning.)
Ferrule
(Sleeve)
Copper
Plastic Water Tubing
to Ice Maker
Fill Tube
Steel Clamp
and Screw
8. Turn ON water supply at shutoff
valve and tighten any connections
that leak.
Braided
Flexible
Stainless
Steel
Water Line
Water Valve
Bracket
Valve Inlet
Water Valve
6 ft minimum (1.8 m)
braided flexible stainless steel
water line from household water supply
Plastic Water Tubing
to Ice Maker
Fill Tube
(Include enough tubing to allow
moving refrigerator out for cleaning.)
Figure 2
To Connect Water Supply Line To
The Ice Maker Inlet Valve
1. Disconnect the refrigerator from the
electrical power source.
2. Place the end of the water supply
line into a sink or bucket. Turn ON
thewatersupplyandushthesup-
ply line until the water is clear. Turn
OFF water supply at shutoff valve.
3. Remove plastic cap from water valve
inlet and discard cap.
4. If you use copper tubing - Slide
brass compression nut, then ferrule
(sleeve) onto water supply line. Push
water supply line into water valve
inlet as far as it will go (¼ in. / 6.4
mm). Slide ferrule (sleeve) into valve
inletandngertightencompression
nut onto valve. Tighten another
half turn with a wrench; DO NOT
overtighten. See Figure 1.
If you use braided exible
stainless steel tubing - The nut
is already assembled on the tubing.
Slidenutontovalveinletandnger
tighten nut onto valve. Tighten
another half turn with a wrench; DO
NOT overtighten. See Figure 2.
5. With steel clamp and screw, secure
water supply line (copper tubing only)
to rear panel of refrigerator as shown.
6. Coil excess water supply line (copper
tubing only), about 2½ turns, behind
refrigerator as shown and arrange
coils so they do not vibrate or wear
against any other surface.
7. To turn ice maker on, press the ice
maker’s On/Off power switch so the
LED is steadily illuminated.
service
mode
9. Reconnect refrigerator to electrical
power source.

Other manuals for IKEA LAGAN

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IKEA LAGAN and is the answer not in the manual?

IKEA LAGAN Specifications

General IconGeneral
BrandIKEA
ModelLAGAN
CategoryDishwasher
LanguageEnglish

Related product manuals