3. How to use PUSH
1) Turn on the PUSH by
pressing the button.
Indoor temperature and
humidity level will be
checked automatically.
2) Press the button again to change to measuring mode.
Ultrasonic waves will measure the distance to the ground.
Since ultrasonic waves spread vertically & horizontally,
make sure there are no obstacles like walls and/or
toys nearby.
※
Make sure the person being
measured keeps his/her
arms by his/her sides.
This will help make sure
the ultrasonic waves are
not being obstructed.
※
To turn it off, press the button for 3 seconds or
let it idle for 20 seconds.
4) Press the button to measure. You can re-measure the
height by pressing the button when you see horizontal
bar on the screen.
“Please press the button ”
InBody [USA]
13850 Cerritos Corporate Dr., Unit C, Cerritos, CA 90703, USA
E-mail: contact@inbody.com Website: https://www.inbody.com
•
This product uses ultrasonic waves to measure height easily and quickly.
•
Please read the ‘User’s Manual’ before using the product.
1. Product Components
The PUSH consists of the following components.
Please make sure all of the components are present.
➊
Temperature sensor
➋
LCD Screen
➌
Button
➍
Ultrasonic Wave Sensor
➎
Battery Cover
➍
➎
➊ ➋ ➌
➊
➋
2. Appearance and Part Names
➊
PUSH
➋
Battery – AAA(1.5V)
×
4EA
➌
User’s manual
3) Place the end of the PUSH that doesn’t have the
ultrasonic wave sensor on the top of the head.
Balance the PUSH vertically and horizontally until
“ ” is displayed on the screen.
Top of
the head
To Next Page
Need help?
General
