SAR tests are conducted using standard operating positions accepted by the
FCC with the mobile device transmitting at its highest certified power level in all
tested frequency bands. Although the SAR is determined at the highest certified
power level, the actual SAR level of the mobile device while operating can be
well below the maximum reported value. This is because the mobile device is
designed to operate at multiple power levels so as to use only the power
required to reach the network. In general, the closer you are to a wireless base
station antenna, the lower the power output of the mobile device.
Before a new model mobile device is available for sale to the public, it must be
tested and certified to the FCC that it does not exceed the SAR limit established
by the FCC. Tests for each model mobile device are performed in positions and
locations (e.g. near the body) as required by the FCC.
By typical operations, this mobile device has been tested and meets FCC SAR
guidelines.
Use of other accessories may not ensure compliance with FCC RF exposure
guidelines. The FCC has granted an Equipment Authorization for this mobile
device with all reported SAR levels evaluated as in compliance with the FCC RF
exposure guidelines.
SAR information on this and other model mobile devices can be accessed
online on the FCC’s website through http://transition.fcc.gov/oet/rfsafety/sar.html.
To find information that pertains to a particular model mobile device, this site
uses the mobile device FCC ID number, which is usually printed somewhere on
the case of the mobile device.
Once you have the FCC ID number for a particular mobile device, follow the
instructions on the website and it should provide values for typical or maximum
SAR for a particular mobile device. Additional SAR information can also be
obtained at http://www.fcc.gov/encyclopedia/specific-absorption-rate-sar-
cellular-telephones.
IFETEL Statement
La operación de este equipo está sujeta a las siguientes dos condiciones:
1) es posible que este equipo o dispositivo no cause interferencia perjudicial y
2) este equipo debe aceptar cualquier interferencia, incluyendo la que pueda
causar su propia operación no deseada.
www.insigniaproducts.com
8
NS-P08A7100
To Next Page
Loading...
Need help?
General