EasyManuals Logo

Insignia NS-PCHDEDS19 User Manual

Insignia NS-PCHDEDS19
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
PACKAGE CONTENTS
Dual Hard Drive Docking Station
• Power adapter (12V/3A)
USB 3.0 cable USB 3.0 Type B to USB 3.0 Type A
Quick Setup Guide
Note: The USB 3.0 OUT port cannot be used to
connect a computer.
SYSTEM REQUIREMENTS
Windows OS:
Windows® 10, Windows® 8.1, Windows® 8,
Windows®7
Linux Kernal:
Linux 2.4.1 and later versions
Mac OS:
Mac OS X 10.6 and later versions
FEATURES
Fashionable design provides remarkable performance
Supports all 2.5" & 3.5" SATA I/II/III hard drives
Maximum capacity of each bay is up to 8 TB
Plug and play, no drivers needed
Supports SATA and USB 3.0 transfer speed up to 5 Gbps
LED indicator lets you check working status
Supports MTT (Multiple Transaction Translator)
Reads two discs (SSD and HDD) simultaneously.
Before using your new product, please read these instructions to prevent any damage.
HARD DRIVE DOCKING STATION
Hard Disk:
1 Insert an SSD or HDD into a slot on your docking
station. You can use both slots at the same time.
CAUTION: To avoid damaging the equipment,
make sure that the SSD/HDD is inserted in the
correct direction.
2 Connect the USB cable to the USB 3.0 IN jack on the
docking station and to an available USB port on
your computer.
3 Connect the power adapter to the DC IN jack on the
back of your docking station, then turn on your
docking station and the computer. The docking
station LED blinks until the computer identies your
station, then the LED lights steady.
4 If this is the rst time you are using an SSD or HDD,
follow your computer's operating system
instructions to format the disk.
5 Follow your computer's operating system
instructions to transfer data to or from your
computer. The docking station LED blinks while data
is transferring.
6 When the transfer is complete, turn o power to the
docking station by pressing the power switch. Press
the eject button on the side of your docking station,
then remove the SSD or HDD.
USB Devices:
You can use the USB 3.0 OUT port to connect USB
devices. This jack provides two-way transmission
between the USB device and an HDD, an SSD, or a
computer.
QUICK SETUP GUIDE
Dual Hard Drive
Docking Station
NS-PCHDEDS19
Eject
Buttons
Front view
Back panel view
Power Switch
USB 3.0 OUT
USB 3.0 IN
Power adapter
jack

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Insignia NS-PCHDEDS19 and is the answer not in the manual?

Insignia NS-PCHDEDS19 Specifications

General IconGeneral
BrandInsignia
ModelNS-PCHDEDS19
CategoryDocking Station
LanguageEnglish