INTERMATIC INCORPORATED | 1950 Innovation Way, Suite 300 | Libertyville, Illinois 60048 | www.Intermatic.com2
PE700 Series Smart Wi-Fi TimerProgramming Guide: Models PE723P, PE733P
3. Then, Press “NEW TIMER”.
NOTE: Once notified, press the “MODE” button on the unit until the Network
light flashes green, this will enter pairing mode. This pairing message is a one
time pairing process between Device and Connect account
4. Name the device and select “Next”.
(Note: Letters, numbers, and spaces are all acceptable characters)
5. Configure Outputs (C1,C2,C3).
Select Yes to combine circuits 1 and 2 into a DPDT circuit. On a three circuit,
circuit 3 will always be independent.
Select No for one to three 120 VAC Outputs.
Optional Override Configuring
1. Choose Normal or Extended Override value for each available Output.
Normal: Off to On - Turns on for 120 minutes before turning off.
On to Off - Remains off regardless of schedule until overridden on again.
(Or until the next scheduled event.)
Extended: Off to On - Defaults on for 120 minutes before turning on Override
time setting value expires, then checks and returns to scheduled state.
On to Off - Defaults to 120 minutes before turning off or Override time setting
value expires, then checks and returns to scheduled state.
View/select which circuits are enabled and press “Next”.
NOTE: Each circuit can be renamed accordingly, but this step is not required.
240 V Application 120 V Application
2. Configure Inputs.
Select the type of Override: Switch, Photo Control or Presence Sensor. Next,
select the outputs to control for each Override. When all Overrides are set,
press “Next”.
3. Press “Connect to Network” or “Finish Setup Now” if you are not ready
to connect the device.
To Next Page
Loading...
Need help?
General
