SALTWATER SYSTEM OPERATION (continued)
7. Boost cycle
• If the test result is below 0.2 ppm, press and hold “BOOST” button for 5
seconds until the indicator lights up and the LED display displays
“80”. This
indicates that the saltwater system has started copper ion production. You can
press and hold the “BOOST” button for another 5 seconds until the indicator is
off, which will cancel the Boost cycle.
Note: Once the system has started copper ion production, the boost button
can’t be re-set until the power switch is off.
•
The boost operating hours is 4 times the amount of time programmed into the
system, i.e. if your saltwater system operating time is 2 hours, the boost procedure
will run 4 x 2 = 8 hours. After boost procedure has been completed, the system
will automatically switch to the normal working mode.
• After a heavy rain or if the pool is dirty, press the “BOOST” button to shock the
pool again.
8. Test pool water regularly:
For the maximum pool volume of 50 000 L, it will take from 2 to 3 days for the
copper concentration to reach the recommended level, when the system is set
at its maximal intensity.
Maintain 1-3 ppm of free available chlorine until the copper concentration
reaches 0.2-0.3 ppm. Until then, copper levels should be checked daily with a
test kit. Once the copper concentration has reached the required level,
maintain 0.6 - 3 ppm of free available chlorine.
The presence of organic matter in swimming pool water reduces the effectiveness
of sanitizers. Reducing sanitizer levels from 1- 3 ppm to 0.6 - 3 ppm is possible only
when the organic matter content in swimming pool water is controlled.
Once the copper level is balanced, test the pool water daily to maintain the free
available chlorine level between 0.6 - 3 ppm.
NOTE: A High copper ion concentration may cause blonde hair to exhibit a
green colour. To prevent this, wear a swimming cap during swimming, and wash
hair with special shampoo after using the pool.
See “Troubleshooting Guide”.
9. Stand-by/power saving mode:
• When the cycle ends, the green “SLEEP” indicator on the control panel lights
up and the LED display flashes “93”. The system is now in Stand-By mode.
After a while, it shuts down and sets itself in a Power Saving mode. The system
will automatically turn itself back on in 24 hours, starting its daily cycle of
chlorine production.
• The “SLEEP” indicator stays on, while the system is in the Power Saving
mode. The LED display however, goes blank after 1 hour. Press any button (
or ) to view the last LED code.
10. Running the pump alone without the Saltwater System:
To run the pump alone without the Saltwater System function,
press and hold both ( ) and ( ) buttons for 5 seconds
until you hear a “beep” and the LED display shows “FP”.
The pump is now operating alone. To stop the pump,
manually turn the switch OFF. NOTE: The pump cannot
be operated alone under an automatic timer mode.
IMPORTANT: To keep the initial automatic operating cycle
setting of the Saltwater System, turn the switch ON, the
LED display shows “FP”, then unlock and lock the keypad
controls again, see previous steps 2 and 4. The LED display
shows the initial input hours and the Saltwater System cycle
repeats again.
SAVE THESE INSTRUCTIONS
Page 22
To Next Page
Loading...
Need help?
General
