86
A
S AVE THESE INSTRUCTIONS
(86IO) EASY SET POOL ENGLISH 7.5” X 10.3” PANTONE 295U 04/19/2022
English
Page 8
POOL SETUP (continued)
4. Filling of the pool
• Before filling the pool with water, ensure that the drain plug inside the pool is closed and that the drain
cap on the outside is screwed on tightly. Fill the pool with no more than 1 inch of water. Check to see
whether the water is level.
IMPORTANT: If the water in the pool flows to one side, the pool is not completely level. Setting
up the pool on unleveled ground will cause the pool to tilt resulting in the sidewall material
to bulge and a potential collapse of the pool. If the pool is not completely level, you must drain
the pool, level the area and re-fill the pool.
• Smooth out the bottom liner wrinkles (from inside the pool) by
pushing out where the pool floor and pool sides meet. Or, (from
outside the pool) reach under the side of the pool , grasp the
pool floor and pull in an outward direction. If the ground cloth is
causing the trouble, have 2 adults pull from opposite sides to
remove all wrinkles
(see drawing 4)
.
•
Now fill the pool with water. The pool liner walls will rise while
you are filling it
(see drawing 5)
.
• Fill the pool with water up to the bottom of the inflated ring which
is the recommended fill line level
(see drawings 1 and 6).
IMPORTANT
Before allowing anyone to use the pool, hold a family meeting. Establish a set of rules that
include, at a minimum, the important safety rules and general aquatic safety information in this
manual. Review these rules on a regular basis and with all users of the pool, including guests.
4
5
6
To Next Page
Loading...
Need help?
General
