(150PO) AP619C BUILT-IN ELECTRIC PUMP ENGLISH 4.875” X 7.25” 06/15/2018
English
150
PO
READ AND SAVE THESE INSTRUCTIONS
Page 2
INFLATION
1. Plug in the AC line cord into an AC electrical outlet. See Fig
(1)
.
2. Slide the switch up to the inflation mark (
). See Fig
(2)
.
PARTS REFERENCE
FIG (1)
√
110 -120 V
220 – 240 V
NOTE:
Drawings for illustration purpose only. May not reflect actual product. Not to scale. Due to a
policy of continuous product improvement, Intex reserves the right to change specifications and
appearance, which may result in updates to the instruction manual, without notice.
OPERATING INSTRUCTIONS
General
•
This appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized
outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
•
For inflatable products with a total air volume up to 2 cubic meter (70 cubic feet), which correspond
to an expected inflation time of about 5 min and 30 sec.
Maintenance instructions:
•
No air pump maintenance is required. Air pump has no user serviceable parts.
•
For cleaning use only mild soapy solution. Do not use any chemicals.
•
In case of repairs, use only common PVC repair glue and patches.
SERVICING OF A DOUBLE-INSULATED PRODUCT:
In a double-insulated product, two systems of insulation are provided instead of grounding. No
grounding means is provided on a double-insulated product, nor should a means for grounding
be added to the product. Servicing of a double-insulated product requires extreme care and knowledge
of the system, and should be done only by qualified service personnel. Replacement parts for a
double-insulated product must be identical to those parts in the product. A double-insulated product
is marked with the words “DOUBLE INSULATION” or “DOUBLE INSULATED” and with the symbol .
Part Descriptions:
1. AC line cord
2. Switch
3. Inflation mark (
)
4. Off mark (
)
5. Deflation mark (
)
6. Air passage
7. Cord compartment
8. Airbed
FIG (2)
1
5
4
3
2
8
6
7
To Next Page
Loading...
Need help?
General
