(108) MODEL 636T FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/06/2016
108A
SAVE THESE INSTRUCTIONS
English
Page 8
FILTER PUMP HOSE CONNECTION SETUP
It is essential to change any damaged element or set of elements as soon as possible. Use
only parts approved by the manufacturer.
1
. Remove the Krystal Clear™ filter pump and hoses from the packaging.
2
. Place the filter pump in such a manner, that you can easily assemble the hose
(7)
connections to the plunger valve. Ensure the filter pump is accessible at all time for service
and maintenance.
Note: Some regional regulations may require the filter pump to be mounted on a
stationary platform. There are two mounting holes located in the pump base for this
reason. Consult your local authorities for filter-pump mounting requirements.
3
. Grasp the two pump hoses
(7)
and connect the hose nuts to the filter pump.
4
. In a counter-clockwise motion unscrew the threaded filter housing collar
(1)
from the filter
housing. Place it in a safe place.
5
. The filter pump is an airtight system. Turn the top air release valve
(2)
once or twice in a
counter-clockwise motion.
DO NOT remove the air release valve from the top cover, as
water will expel with force if the motor is turned on. This may cause injury.
6
. Grasp and remove the filter housing cover
(4)
. Check to see if a cartridge is inside the
housing. If yes, replace the cover, finger tighten the housing collar
(1)
back onto the filter
housing.
7
. Gently finger tighten the sediment release valve located at the bottom of the housing to be
sure that water does not leak out.
8
. When the pool is filled connect the hose from the bottom of the filter housing to the highest
strainer assembly. You will find the hose connection at the bottom of the plunger valve
assembly. Use the hose nut to attach the hose.
9
. Connect the second hose which is fixed to the middle of the motor housing to the
remaining liner connection.
WARNING
Position this product away from the pool, so as to prevent children from
climbing on it and accessing the pool.
The installation instruction shall provide information on requirements specified for the electrical
installation and shall include reference to national wiring rules.
THREADED FILTER
HOUSING COLLAR
HOSE NUT
OUTLET HOSE
WATER LEVEL
ADJUSTABLE POOL
INLET JET NOZZLE
INSIDE LINER
WALL
THREADED
STRAINER
CONNECTOR
OUTSIDE LINER
WALL
(ILLUSTRATION NOT TO SCALE)
INLET HOSE
W
A
T
E
R
F
L
O
W
W
A
T
E
R
F
L
O
W
PLUNGER VALVE
ASSEMBLY
FILTER CARTRIDGE
INSIDE
MOTOR
HOUSING
AIR RELEASE
VALVE
FILTER HOUSING
COVER
HOSE O-RING
POWER CORD
HOSE
O-RING
AIR JET VALVE
INLET THREADED AIR
CONNECTOR
To Next Page
Loading...
Need help?
General
