128
SAVE THESE INSTRUCTIONS
Page 15
(128) MODEL SF20220R SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 09/08/2009
English
SETUP INSTRUCTION (continued)
2. Lower the 6-way valve cover over the tank slowly, and ensure the bypass pipe
protruding underneath the 6-way valve cover fits securely into the center
pipe (3) top opening (see drawing 22). Make sure the tank o-ring is securely
fitted between the top edge of the tank groove and the 6-way valve cover edge.
IMPORTANT: There are three hose connection ports on the 6-way valve,
ensure the outlet connection (from filter to the pool) on the valve is facing
towards the pool, and the inlet connection (from motor to valve) is aligned
with the motor outlet (see drawing 23).
22
23
3. Place an L-shape o-ring (9) on the 6-way valve inlet connection and on the
pump motor outlet. In a clockwise motion connect the sand filter
interconnecting hose (11) between the pump motor outlet and the 6-way valve
inlet connection (see drawing 24).
4. Remove the clamp bolt cover and the clamp bolt (8), and install the flange
clamp around the tank and 6-way valve flanges (see drawing 25).
5. Insert the clamp bolt (8) into the pre-installed nut on the clamp, and securely
tighten it with the wrench (12) supplied. Replace the clamp bolt cover back.
(see drawings 26.1 & 26.2).
SETUP INSTRUCTIONS
24
25
26.1
WARNING
Improper tank valve and clamp assembly could cause the valve and clamp
to blow off and cause serious injury, property damage or death.
26.2
WATER
INLET
WATER
OUTLET
To Next Page
Loading...
Need help?
General
