Intex SF70110 User Manual

161
SAVE THESE INSTRUCTIONS
Page 12
(161) MODEL SF15110 SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/26/2012
English
4. In a clockwise motion screw filter housing nut (17) onto the motor water inlet
(See drawings 12.1 & 12.2).
5. Replace the basket (16) and leaf trap cover (14) back to the pre-filter housing
(See drawings 13.1 & 13.2).
SETUP INSTRUCTIONS (continued)
SETUP INSTRUCTIONS
Sand tank installation:
1. Place the tank support base on the selected location.
2. Place the tank on the tank support base (See drawing 14.1).
3. Connect the motor pre-filtering assembly unit to the tank support base (See
drawing 14.2). NOTE: Ensure the pre-filter housing water inlet hose connection
is facing towards the pool.
  IMPORTANT:Somecountries,especiallyintheEuropeancommunity, 
  requiretheproducttobesecuredtothegroundortoabaseina
permanent upright position. Check your local authorities to determine if
  thereisaregulationinyourarearegardingabove-the-groundswimming
  poolfilter-pumps.Ifyes,thentheproductcanbemountedtoaplatform
using the two holes located in the base. See drawing 14.3.
The product can be mounted on a cement base or onto a wooden
plat form to prevent accidental falling over.
 • Themountingholesare6.4mmindiameterandspaced160mm 
apart.
 • Usetwoboltsandlocknutswithamaximumof6.4mmindiameter.
12.2
12.1
13.1 13.2
14.1
14.2
mm
160
14.3
17
17
14
16
35

Intex SF70110 Specifications

General

Brand	Intex
Model	SF70110
Category	Swimming Pool Pump
Language	English