161
SAVE THESE INSTRUCTIONS
Page 14
(161) MODEL SF15110 SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/26/2012
English
6-way valve installation:
1. Lower the 6-way valve over the tank slowly, and ensure the bypass pipe
protruding underneath the 6-way valve fits securely into the center pipe hub (7)
top opening (see drawing 19).
IMPORTANT: There are three hose connection ports on the 6-way valve,
ensure the outlet connection (from filter to the pool) on the valve is facing
towards the pool, and the inlet connection (from motor to valve) is aligned
with the motor outlet (see drawing 20).
SETUP INSTRUCTIONS
SETUP INSTRUCTIONS (continued)
WARNING
Improper tank valve and clamp assembly could cause the valve and clamp
to blow off and cause serious injury, property damage or death.
20
WATER
INLET
WATER
OUTLET
2. Place an L-shape o-ring (11) on the 6-way valve inlet connection and on the
pump motor outlet. In a clockwise motion connect the sand filter
interconnecting hose (13) between the pump motor outlet and the 6-way valve
inlet connection (see drawing 21).
3. Remove the clamp bolt, and install the clamp around the tank and 6-way valve
flanges, then replace the clamp bolt and use a phillips screwdriver (not
included) to tighten it (see drawings 22)
19
21
22
7
13
4
To Next Page
Loading...
Need help?
General
