To Next PageTo Next PageHow to fix no or low water production in Ispring RCC1UP?
If your Ispring Water Filtration System is producing no or low water, there are several potential causes. First, ensure that the feed water valve is turned on. If not, turn it on. Next, check that the tank valve is also turned on. Finally, inspect the tubing for any kinks and straighten them if necessary.
What to do if my Ispring RCC1UP has low water production?
If you're experiencing low water production with your Ispring Water Filtration System, several factors could be responsible. Start by following the recharging tank procedure to address potential storage tank issues. Clogged filters can also restrict water flow, so consider replacing them. Check for any kinked tubing and straighten it out. Lastly, a clogged flow restrictor can also cause low production, so replace it if necessary.
Why does the drain water never shut off on my Ispring Water Filtration System?
If your Ispring Water Filtration System's drain water never shuts off, it could be due to several reasons. The auto shut-off valve might be worn out and need replacement. The valve might also be becoming ineffective, requiring you to follow the tank recharging procedure. Insufficient pressure in the storage tank may also be the cause, so try increasing the feed water pressure. If the water supply pressure is near 45 psi or below, there isn't anything you can do. Clogged filters due to cold water temperature can also cause this issue, so consider replacing the filters.
How to fix a leak at the filter housing of Ispring RCC1UP Water Filtration Systems?
If you notice a leak at the filter housing of your Ispring Water Filtration System, first ensure that the housing is properly tightened. If the leak persists, check the O-ring for damage or misalignment; realign or replace it as needed. If the housing has cracks, it will need to be replaced.
How to repair a leak at fitting thread on Ispring RCC1UP Water Filtration Systems?
If you find a leak at a fitting thread in your Ispring Water Filtration System, first ensure it is properly tightened, using Teflon tape if necessary. If the fitting is cracked, it needs to be replaced.
Why does my Ispring RCC1UP have bad-tasting water?
If your Ispring Water Filtration System water tastes bad, discharge water from the tank to flush the system. Also, check the tubing connection against the flow diagram to ensure it's correct.
Why is the water from my Ispring RCC1UP Water Filtration Systems milky or cloudy?
If your Ispring Water Filtration System produces milky or cloudy water, this is normal due to air in the system and filters. Continue using it for 2 weeks.
What causes vibrating noise in Ispring Water Filtration Systems?
If your Ispring Water Filtration System is making vibrating noise or very loud high pitch noise, the noise may be coming from the auto shut-off valve. If the noise is too unbearable, the valve should be replaced.
Why is my Ispring Water Filtration Systems making noise from drain?
If your Ispring Water Filtration System is making noise from the drain, it may be because the saddle valve is mounted too high. Lower the saddle valve. Keep in mind that waste water to drain is normal when the system is making water, and the drain should stop when the storage tank is full.
General| Filtration Stages | 5 |
|---|---|
| Warranty | 1-year limited warranty |
| Type | Reverse Osmosis System |
| Water Production Rate | 75 gallons per day |
| Certifications | NSF/ANSI 58 |
| Filter Type | Sediment, Carbon Block, RO Membrane, Post Carbon |
| Inlet/Outlet Connection | 1/4 inch |
| Operating Temperature | 40-100°F |
| NSF/ANSI Certified | NSF/ANSI 58 |
| Filter Lifespan | 6-12 months (pre-filters), 2-3 years (RO membrane) |
| Filter Life | 6-12 months (pre-filters), 2-3 years (RO membrane) |
| Operating Pressure | 40-80 psi |
