ITech IT6800A Series User Manual

Functions and Characteristics
Copyright © Itech Electronic Co., Ltd. 18
LIST
SET
LIST
STATE
OFF
Disable list function
ON
Enable list function
LIST
LOAD
Recall list operation file (FILE0-FILE3)
LIST EDIT
TIME
(SEC)
SEC
Select second as time unit
MIN
Select minute as time unit
VSET
Set step voltage
ISET
Set step current
SEC
Set step delay time (0.1-9999.9)
NEXT
(YES)
YES
Continue to edit the next step
NO
finish list file edit
REPET
1-65535
Set repeat count
SAVE
NO
Do not save the current list file. In
this mode, the file can only run
for one time. Once you quit the
list mode or turn off the unit, the
file cannot be recalled.
FILE0-FILE3
save list file to assigned memory
location
EXIT
Quit list menu
POWER
INFO
MODEL
Model information
VER
Firmware version
SN-1
First six number of SN
SN-2
Middle six number of SN
SN-3
Last six number of SN
EXIT
Quit information menu
EXIT
MENU
Quit menu
IT6800B series
MAX
VOLT
Set the Maximum Voltage
OCP
SET
OFF
Disable OCP function.
ON
Enable OCP function ON(0～7.0000A)
SYST
SET
P-MEN
(RESET)
Reset
Return to the factory default setup value
Keep
“Remembers” and restores the operating
parameters of power supply (voltage,
current settings...) before power was
turned off. The next time you power up the
unit, the parameters will be recalled
automatically.
P-OUT
(OFF)
OFF
Set the Power to OFF state after power up.
Keep
“Remembers” and restores the power
ON/OFF state of power supply before
power was turned off. The next time you
power up the unit, the on/off state will be

ITech IT6800A Series Specifications

General

Brand	ITech
Model	IT6800A Series
Category	Power Supply
Language	English