Function and Features
Copyright ©ITECH Electronic Co., Ltd. 25
Digital Volt Meter (DVM)
IT6900 series power supply has four semi-digital voltmeter. This DVM can
measure 0.001V to 61.000V voltage. Press
+
(DVM) button can
enable the measured value display on the VFD screen. Press any key to quit
the display of this value.
Remote sense function
Remote sense can adjusted at the output voltage of the device under test, this
feature allows to compensate the voltage drop on the wire between the front
panel terminals of the power supply and the device under test.
Use local sense
:
Local sense doesn’t compensate the voltage drop on the connection wire, the
operation is:
1. Use the short clips on the back panel of the instrument, or install wire
between + and S+, - and S-.
2. Connect the positive and negative terminals of the front panel to the device
under test.
Use remote sense:
Remote sense compensate the voltage drop on the connection wire, the
operation is:
1. Disconnect the wires/short clips between + and S+, - and S-.
2. Connect wires from S+, S- to the device under test.
3. Connect wires from +, - to the device under test (Except
IT6952A/IT6953A/IT6952B/IT6953B).
For IT6952A/IT6953A/IT6952B/IT6953B:
To Next Page
Loading...
Need help?
General
