ITech IT8511+ Manual

10
29H
Enquire the operation mode.
2AH
Set CC mode current value
2BH
Enquire CC mode current value
2CH
Set CV mode voltage value
2DH
Enquire CV mode voltage value
2EH
Set CW mode watt value
2FH
Enquire CW mode watt value
30H
Set CR mode resistance value
31H
Enquire CR mode resistance value
32H
Set CC mode transient current and timer parameter.
33H
Enquire CC mode transient parameter
34H
Set CV mode transient voltage and timer parameter.
35H
Enquire CV mode transient parameter
36H
Set CW mode transient watt and timer parameter
37H
Enquire CW mode transient parameter
38H
Set CR mode transient resistance and timer parameter
39H
Enquire CR mode transient parameter
3AH
Set the list operation mode (CC )
3BH
Enquire the list operation mode.
3CH
Set the list repeat mode (ONCE / REPEAT)
3DH
Enquire the list repeat mode.
3EH
Set list steps counts.
3FH
Enquire list steps counts
40H
Set one of the step’s current and time values.
41H
Enquire one of the step’s current and time values.
4CH
Save list file in appointed area.
4DH
Recall the list file from the appointed area.
50H
Set timer value of FOR LOAD ON
51H
Enquire timer value of FOR LOAD ON
52H
Disable/Enable timer of FOR LOAD ON
53H
Enquire timer state of FOR LOAD ON
54H
Set communication address
55H
Enable/Disable LOCAL control button.
56H
Enable/Disable remote sense mode.
57H
Enquire the state of remote sense mode.
58H
Set trigger source.
59H
Enquire trigger source.
5AH
Sending a trigger signal to trigging the electronic load.
5BH
Saving user’s setting value in appointed memory area for recall.
5CH
Recall user’s setting value in appointed memory area.
5DH
Set function mode(FIXED/SHORT/TRAN/LIST/BATTERY).
5EH
Enquire function mode state.
5FH
enquire input voltage, current, power and relative state
01H
Get the information of E-Load(rated current/voltage,min voltage,max power,max

ITech IT8511+ Specifications

General

Brand	ITech
Model	IT8511+
Category	Test Equipment
Language	English