7
600 Series
Turfcat
Tractors
7. VERIFY DECK LEVELING
a) Place the deck on level ground and determine
whether the deck appears to be level.
b) Two spacers and self tapping screws are provided
to adjust deck height at the push arms.
Disconnect the push arm and attach one spacer
L, as illustrated. Reconnect push arm and verify
leveling.
c) Repeat operation with other spacer if needed.
Check deck leveling. With the deck on flat ground
verify the deck is level. If not level, add one or
more spacers S1 to the top of the push arm on the
low side, and recheck.
6. HEIGHT ADJUSTMENT PINS
a) Identify with reference to the height of cut chart on
the deck belt cover or in the cutterdeck section of
this manual the desired hanger pin location.
b) With the cutterdeck slightly raised, insert an
adjustment pin in the same location for each
hanger.
5. ATTACH LIFT CHAINS TO DECK
a) Verify that the bottom link of the deck chains
reach the deck bracket mounting holes. If not, the
deck cylinder may need to be further lowered with
the tractor lift lever or the chains checked for
routing problems.
b) Anchor the bottom link of each chain to the
bracket with 5/16-18 x 1-1/4" bolts and washers,
first making sure the chains drop straight without
twisting. Secure with lock nuts.
ASSEMBLY & SETUP
To Next Page
Loading...
Need help?
General
