5
600 Series
Turfcat
Tractors
ASSEMBLY & SETUP
2. PREPARE TRACTOR
a) Start the tractor. Push the lift lever forward to fully
extend the deck chains. Stop the engine.
b) Mount each push arm to a tractor differential
bracket B using a 5/8-18x3-1/2 hex head bolt, two
spacers S, lockwasher and nut N arranged as
shown. Tighten securely.
CUTTERDECK ASSEMBLY & SETUP
Left arm mounting shown
1. CASTER WHEELS
a) Uncrate the deck. Remove the casters from deck mounting plates P. Reassemble to the mounting plates
with reference to the height of cut chart on the deck cover or in the cutterdeck section of this manual.
b) Place blocks under the rear of the deck so that the bottom edge is approximately parallel with the ground.
Caster mounted in "HIGH" position
To Next Page
Loading...
Need help?
General
