Page 80
J-400
lter by rotating it counterclockwise. For cleaning procedures see
step 6 below. Once the lter has been cleaned or replaced, reinstall
it into the skimmer below the polishing bag. Replace bag, then install
lter lid by rotating it clockwise until you feel it latch in place. DO
NOT FORCE LID! FINGER TIGHT ONLY!
4. Remove the ProClear skimmer assembly (A) by gently lifting upward
from the lter bucket.
5. Remove the ProClarity™ lter cartridge by rotating it
counterclockwise to unthread it, then remove the lter pin and
disconnect the lter from the lter canister.
6. Clean the ProClarity™/ProClear lter cartridges and lter canister
with a garden hose and high pressure nozzle. Rinse debris from the
lter pleats beginning at the top and working your way downward.
Continue, one section at a time until you have cleaned all debris from
the lter pleats. Replacement lter cartridges may be purchased from
your authorized Jacuzzi dealer.
C.
A
DANGER: TURN POWER TO SPA OFF! TO DECREASE
OPERATE SPA WHEN FILTER IS NOT PROPERLY INSTALLED
(Spa
Shell)
Lift the cover upward to
access lter cartridges.
C
Remove the ProClarity
debris bag from clips
and then clean out
debris.
D
(Spa Shell)
Rotate each lter
cartridge handle
counterclockwise to
unthread from mating
wall tting.
Debris
Bag
To Next Page
Loading...
Need help?
General
