Jacuzzi Proclear User Manual

WHEN: WHAT TO DO:
Run spa according to recommendations supplied to you by the manufacturer of your spa.
Test the water with the Nature
2®
Spa Test Strip (or equivalent). If the MPS
*
level is low, add
1 tablespoon of MPS
*
to spa per 250 gallons (approx. 1000 liters).
(Note: 1 tablespoon is approximately ½ ounce or 16 grams)
Use the Nature
2
Spa Test Strip (or equivalent) to test the spa water after each addition of MPS.
*
If the test strip indicates levels below the OK range, add 1 tablespoon MPS
*
to spa per 250 gallons and re-test. Enter
spa only after test strip indicates a sufficient level of MPS.
*
Add 1 tablespoon of MPS
*
to spa per 250 gallons (approx. 1000 liters)
Adjust the pH, total alkalinity and hardness as needed. A convenient way to test pH and total alkalinity is the use of
the Nature
2®
Spa Test Strip.
Drain and refill your spa. Replace proclear, repeat sanitizer start-up.
Shock treat with 1.5 tablespoons of an EPA registered source of dichlor** per 250 gallons (approx. 1000 liters) to
remedy problems which may occur when bathing loads are high, when successive MPS
**
test strip reading indicate
high demand, when water appears hazy or dull, when unpleasant odors or eye irritation occur, after heavy wind and
rainstorms or if foam develops.
EVERY DAY:
AFTER EACH USE:
ONCE PER WEEK:
EVERY 4 MONTHS:
AS NEEDED:
BEFORE EACH USE:
NOTE:
As an alternative to MPS
*
, an EPA registered source of dichlor** may be substituted: 1 tablespoon dichlor**= approximately 3 tablespoons MPS.
*
IMPORTANT: Perform start-up procedures for spas which have been unused or unattended. The proclear™ is not to be used with products
containing biguanides. If biguanide or bromine products are being used, BE SURE TO DRAIN AND REFILL SPA WITH FRESH WATER WHEN USING
THE LOW CHLORINE RECIPE.
REPLACEMENT INTERVALS  FOR PROCLEAR
A cartridge lasts four (4) months. The cartridge should not be used longer than four (4) months.
STORAGE/DISPOSAL:
Storage – store in areas inaccessible to small children. Disposal – After four (4) months of use, discard proclear™ in household trash. Do not save
the cartridge for re-use. The cartridge is manufactured with the mineral media sealed inside. In the unlikely event a cartridge breaks, remove it
and vacuum out any media introduced into the spa.
MINERAL SPA SANITIZER
PRECAUTIONARY STATEMENT
Hazards to Humans and Domestic Animals.
CAUTION
In the unlikely event that a cartridge breaks, mineral media should not be ingested by humans or animals as it may cause gastric distress.
FIRST AID
If Ingested: Call Poison Control Center or doctor immediately for treatment advice.
Proclear™ has been designed to sanitize spas up to 500 gallons.
DIRECTIONS FOR USE:
It is a violation of Federal law to use this product in a manner inconsistent with its labeling.
LOWCHLORINE RECIPE
• Proclear™
• Non-chlorine oxidizer (potassium peroxymonosulfate)
• Nature
2
® Spa Test Strips or equivalent (*MPS, pH, total alkalinity)
• pH, hardness, and total alkalinity adjusting chemicals
• Dichlor**, EPA registered source
PROCLEAR™ COMPATIBILITY
ATTENTION
Not to be used with product containing biguanides. If biguanide or bromine products are being used, be sure to drain and rell with fresh water.
STARTUP
Before starting up a new proclear, clean debris and algae out of the spa and spa equipment.
IMPORTANT: Do not install the new proclear until the spa water is clean and chemically balanced.
Balance spa water before installing proclear.
pH 7.2-7.6
Calcium Hardness 200-400 ppm
Total Alkalinity (TA) 80-120 ppm
INSTALL PROCLEAR™
Add 1 ½ tablespoons of dichlor** to spa per 250 gallons (approx. 1000 liters). Note: 1 ½ tablespoons is approximately ¾ oz or 24 grams.
Do not enter the spa if the free available chlorine residual is over 5ppm.
* potassium peroxymonosulfate
** sodium dichloroisocyanurate dihydrate
proclear
TM

Jacuzzi Proclear Specifications

General

Brand	Jacuzzi
Model	Proclear
Category	Hot Tub
Language	English