EN 3
SET UP
TURNING ON YOUR TURNTABLE
A – Attach the correct adapter plug for your region
to the adapter. Plug the supplied power cord into the
power input on the back of the turntable, and plug into
a wall socket.
B – Press the power button to turn on your turntable
to turn it on.
OUTPUT
AUX IN POWER
DC IN
CONNECTING DEVICES
Bluetooth®
A – Make sure the Bluetooth® device you would like to pair to
is powered on and in pairing mode.
B – Press the Bluetooth® button on the front of your turntable
twice to begin the pairing process.
C – The LED will ash blue when searching for a device, then
turn solid blue once paired.
TIP: If taking a while to pair (+30 secs), press the Bluetooth®
pair button on the turntable 1 more time to re-initiate the
searching feature.
CORDED CONNECTIONS
CAUTION:
Switch off power to all equipment before making connections.
Read the instructions of each component you intend to use
with this unit before proceeding. Be sure to insert each plug
securely. To prevent hum and noise, avoid bundling the signal
interconnection cables together with the power cord.
RCA-to-RCA INPUT
To connect the turntable to devices with RCA input, use an
RCA to RCA cable (available separately). Connect the RCA
plugs on one end of the cable to the L and R sockets on the
back of the turntable and the plugs at the other end to the
corresponding L and R sockets on the back of the device.
OUTPUT AUX IN POWER DC IN
2x
OUTPUT AUX IN POWER DC IN
RCA – AUXRCA – RCA
To Next Page
Loading...
General