EasyManuals Logo

JBL BassPro Go User Manual

JBL BassPro Go
1 page
Page #1 background imageLoading...
Page #1 background image
VII.TROUBLESHOOTING
No audio and POWER INDICATOR is off
NO voltage at BAIT* and/or Revl terrriiriäS Orbay Or rid
ground connection. Check K.altagesat amplifier terminals with
No audio and PROTECT INDICATOR is on
EN
Chæk to if the input •atage is less than gv ar greater than
1GV BAIT + connection and vehicle Ch..ärgngSystem.
In-fine fuse keeps breaking
The wiring is connected incorrectly or there is a short Circüt.
Review installaton precautions and procedures. Check wiring
connectionsa
Distorted audio
Gajn iS not set preparty. Check and adjust settngs. or
SO'LKCE unit rnay defective
Unwanted noise in the audio signal
Radated vehicle någe in the fine-level input eahles Make Sure
poner wire and Signal wires not each Other (run them
down apposite sk:jes of the
Music lacks dynamics or "punch"
use adjustment,
Loudness or audio performance varies with Bluetooth
and volume vary between Phones, you fæl
that the product iS not lcud enough, ctEck your settings
to see if any agustrnents can be rnade to improve audio
periorn•.ance, or try uSng a different audio source Bluetooth;
streaming dev'ice to chterrnne if perfor:rnance improves.
Audio play/pause, forward or track back are slow
to respond in Bluetooth mode
This will vary by Phone Bluetooth streaming Try usirq
a different Bluetooth streaming to see if this irnvyovw
If the problern VX!rsi5ts,cycle the off and the speaker
rest for a few mnutes turning power on.
Audio track is cutoff in first few seconds when using
track forward track back
Thig will by phone and capability of the to
communicate Bluetooth control Torn an external
Tty using a different Bluetooth streamir•o device to see if Onis

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JBL BassPro Go and is the answer not in the manual?

JBL BassPro Go Specifications

General IconGeneral
Bluetooth Version4.2
Power Output100W RMS
Signal-to-Noise Ratio>80dB
Enclosure TypeSealed
InputsBluetooth, 3.5mm Aux
TypePortable Bluetooth Speaker & Subwoofer
Frequency Response40Hz – 20kHz
Battery TypeLithium-ion Polymer
Battery LifeUp to 8 hours (varies by volume level and audio content)
Charging Time3.5 hours

Related product manuals